Inertia Reel Seat Belt - 3 Point Mounting - Long Stalk
Inertia Reel Seat Belt. Designed for 3 point mounting for use in cars without door pillars or in the rear of the car for the rear seats. The
Inertia Reel Seat Belt. Designed for 3 point mounting for use in cars without door pillars or in the rear of the car for the rear seats. The 'stalk' on this version is 300mm long and is suitable for mounting directly to the seat frame, to the side of the transmission tunnel or side sill. Length of webbing 3.2 metres. This belt is made in accordance with the following standards: ECE R 16-06, EEC77/541ff (2005/40), FMVSS 209 and ADR4/04. The reel is designed to be mounted behind the seat, low down with the belt pulling out vertically from the reel and then feeding over your shoulder - it will not work with the belt feeding out in any direction other than vertically. Bolts and Fixings are included.
Securon Static Front Seat Belt and Anchor. (217cm with 45cm Stalk) Securon-300/45 - Securon-300/45
INERTIA FRONT SEATBELT KIT (SECURON) ; GT6 MkI, II & III - ANG Classic Car Parts
Looking for a Suitable Inertia Reel Seat Belt? Is Fitting It a DIY Job?
Inertia Reel Seat Belt - 3 Point Mounting - Short Stalk
Securon Inertia Reel Front Seat Belt and Anchor kit (Black) Securon-500/30 - Securon-500/30
Seats & Seat Belts
Hardware
Reel-type Seat Belts in a Land-Rover Series 1
Mini front inertia real, retractable seatbelt (X1) 300mm stalk – Minisport
Hardware