Edson Marine Steering Hardware: Stainless Wire Rope Clamp - 1/4

Edson’s Stainless Wire Rope Clamps are used to secure the end of the wire rope after it goes through the Take-Up Eye on Quadrants and Drive Wheels. Two each are required for each take-up eye, or four total for a steering installation.
Edson%26rsquo%3Bs%20Stainless%20Wire%20Rope%20Clamps%20are%20used%20to%20secure%20the%20end%20of%20the%20wire%20rope%20after%20it%20goes%20through%20the%20Take-Up%20Eye%20on%20Quadrants%20and%20Drive%20Wheels.%20Two%20each%20are%20required%20for%20each%20take-up%20eye%2C%20or%20four%20total%20for%20a%20steering%20installation.%20Edson's%20Stainless%20Wire%20Rope%20Clamp%26nbsp%3B-%20(665ST-250)%20Key%20Features%3A%20%20%20%20%20Wire%20Rope%26nbsp%3Bacceptance%20%20%26nbsp%3B1%2F4-inch%20%7C%206.4%20mm%26nbsp%3BDia.%20Wire%20%20%20%20%26nbsp%3B

Marine Hardware Essenbay Marine

Johnson Marine Rigging Turnbuckles

Edson Marine Steering Hardware: Stainless Wire Rope Clamp - 1/4-inch Wire Size (665ST-250)

Chain & Wire Rope

Boat Steering Hardware Knobs, Pulleys, Tiller Extensions

Rudder Hardware

Wire Rope Sheaves & Assemblies

Sailboat Steering & Wheels

Marine Hardware Essenbay Marine